Title
Technical Note: Fabricating Cerrobend grids with 3D printing for spatially modulated radiation therapy: A feasibility study
Publication Date
2015
Journal Title
Med Phys
Abstract
Purpose: Grid therapy has promising applications in the radiation treatment of large tumors. However, research and applications of grid therapy are limited by the accessibility of the specialized blocks that produce the grid of pencil-like radiation beams. In this study, a Cerrobend grid block was fabricated using the 3D printing technique. Methods: A grid block mold was designed with flared tubes which follow the divergence of the beam. The mold was 3D printed using a resin with the working temperature below 230 degrees C. The melted Cerrobend liquid at 120 degrees C was cast into the resin mold to yield a block with a thickness of 7.4 cm. At the isocenter plane, the grid had a hexagonal pattern, with each pencil beam diameter of 1.4 cm; the distance between the beam centers was 2.1 cm. Results: The dosimetric properties of the grid block were studied using small field dosimeters: a pinpoint ionization chamber and a stereotactic diode. For a 6 MV photon beam, its valley-to-peak ratio was 20% at d(max) and 30% at 10 cm depth; the output factor was 84.9% at d(max) and 65.1% at 10 cm depth. Conclusions: This study demonstrates that it is feasible to implement 3D printing technique in applying grid therapy in clinic. (C) 2015 American Association of Physicists in Medicine.
Volume Number
42
Issue Number
11
Pages
6269-6273
Document Type
Article
Status
Faculty
Facility
School of Medicine
Primary Department
Radiation Medicine
PMID
DOI
10.1118/1.4932223
This document is currently not available here.
COinS
Comments
Hofstra Northwell School of Medicine and Northwell Health currently do not subscribe to this title. If you are an affiliate and would like to access the full text please request it via interlibrary loan via Hofstra Northwell School of Medicine ILL (faculty and students only) or Northwell Health ILL